TenTec
[Top] [All Lists]

Re: [TenTec] Foot in my mouth...

To: tentec@contesting.com
Subject: Re: [TenTec] Foot in my mouth...
From: Al Gulseth <wb5jnc@centurytel.net>
Reply-to: wb5jnc@centurytel.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 15 May 2012 08:18:19 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Rick,

As far as I'm concerned, no apology is needed. You're causing others to "think 
outside the box" and hopefully helping everyone involved to eventually find a 
realistic solution. (BTW I wish the FCC _would_ actually enforce Part 15 
standards for consumer electronics. I recently did a little power supply 
experimenting with my old Argonaut: I made a coaxial power connector to RCA 
adapter and tried a couple of small switching power supplies. The first was a 
12V 1250 ma "wall wart" which had a small gauge zip cord cable, and the 
second was a 12V 4.16A "brick" which used a standard computer-type IEC power 
cord and had a coaxial output cable with a ferrite choke "bump" molded on the 
cable a couple of inches from the connector. Needless to say, there was a 
stark contrast: the "wall wart" totally wiped out any possible reception. 
The "brick", on the other hand, produced only low-level noise and possibly a 
few "birdies" (which seemed to be coming from the PS enclosure itself as the 
noise level went up if I touched the enclosure.) The bottom line is that it 
wasn't so bad that it couldn't be used for casual operating in my opinion. 
(My comparison "standard" for the test to determine what was coming from the 
power supply and what was coming from elsewhere was a battery.) This just 
goes to show that the issues we're discussing can be overcome with decent 
engineering and manufacturing practices!)

Also, in a previoust post, you said:

<snip> I honestly think people here don't realize that there are some rigs on 
the market today that nobody can generate a clean signal with....  I will 
pick out some screen shots and send to you.  Then maybe you'll understand why 
I am so passionate on this.<snip>

I'd like to encourage you to not just send those screenshots to one person but 
rather to post them to a website or maybe even make them into a YouTube video 
(since that's where things seem to go "viral".) Maybe if more people see your 
work it will help raise awareness of the issue.

TNX/73, Al



On Tue May 15 2012 5:36:52 am Rick - DJ0IP / NJ0IP wrote:
> What was I thinking? (!)
>
>
>
> No, I do not want government regulating our transmitter technology.
>
> I've had worse ideas, but this one was right up there!
>
> I guess I was just thinking out loud and got carried away in the wrong
> direction.  Sorry.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>