Re: [TenTec] Delta II rig control information

[Carl Moreschi <n4py2@earthlink.net>]

The Delta II has an Icom CIV interface in it.  So it takes an Icom 
logging program to work with it.  You must know the CIV address of the 
Delta II and the correct baud rate to hook it up.  There are CIV-to USB 
converters available with an internet search that will allow you to hook 
it up to your computer.
I just searched the internet and the baud rate is 1200 baud and the CIV 
address is 40h.  My N4PY Icom program should work with this.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 6/24/2012 8:43 PM, Kris Merschrod wrote:
> Steve,
>
> Tank you for bringing this up.  A couple of months ago teher was a thread
> here about the right cable - I immediately picked up one cable and then was
> distracted.  I haven't the foggiest idea but will be anxious to see the
> answers too.
>
> Kris KM2KM
> ----- Original Message -----
> From: "Steve Weber"<kd9bo@mac.com>
> To:<TenTec@contesting.com>
> Sent: Sunday, June 24, 2012 7:35 PM
> Subject: [TenTec] Delta II rig control information
>
>
> > Hi  Has anyone out there connected the Delta II to a computer for logger
> > and rig control use?
> > I remember reading somewhere that the settings for an ICOM something or
> > other work with this rig. Any help would be greatly appreciated.
> > I've never done this with any rig, so please be gentle - It's my first
> > time...
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec