Yes, with N4PY software, you can remap all the buttons to do any of more
than 30 functions.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 8/14/2012 6:33 PM, Richards wrote:
> I agree. But they had to go somewhere! And, if they went
> above the keypad, it would make the thing bigger, which
> would be a different ground for beef. (pardon the weak pun.)
>
> I set mine to F1-Mode, F2-Step, and F3C-Sweep
>
> I have not played with it yet, but it seems like Carl's N4PY
> control program allows us to remap all the buttons on the
> keypad, so maybe that is an option. Not sure, as I usually
> run the rig using its front panel knobs and buttons, but I
> sometime use H4PY control program to use a TT RX-320-D
> as an ersatz second-receiver-pan-adapter.
>
>
> Happy days.
> ======================= K8JHR ================
>
>
>
> On 8/14/2012 4:00 PM, Paul DeWitte wrote:
>
>> I have the F1,F2, F3, buttons programed to A=B, split, and reverse. I find
>> that reaching above the knob to use one of the buttons is kind of
>> clumsy/unhandy.
>>
>> It seems to me that they would have been more accessable if they were put
>> above the keypad.
>>
> ________________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|