Cecil: There is a guy near Greenville, SC that works on those things among
other radios.
You might try an email to glenn@dsmlabs.com and see what he says. He does have
a
few of the Omni rigs for test jigs.
73 Clayton N4EV
________________________________
From: chacuff <chacuff@cableone.net>
To: TenTec@contesting.com
Sent: Sunday, September 2, 2012 7:32 PM
Subject: [TenTec] Omni VI Logic board
I'll probably get beat up as many may consider this either a sore subject or a
dead horse or both, but I need to ask. (use your delete key as needed please)
I have been working a bit this afternoon on a VI Option 3 that I acquired as a
spare to my working VI Option 3. It's too nice a radio not to try to fix.
Has anyone gone as far as to determine what seems to be the common failure on
these logic boards. This one has already been worked on by someone. U21 has
been replaced with a like part number chip but in a different package with half
the leads in the board and the other half wired in with wire wrap wire. U20
shows signs of being replaced as well. All else appears to be factory. I have
checked the battery and performed system resets with no effect.
As I understand the radio was sent to Ten-Tec and deemed unrepairable and the
owner sent it to someone else who took a shot at it with no luck.
I haven't begun that task of tracing signals around on the board to determine
if there are proper voltages, clock signals, chip selects and any data moving
about but will soon.
The tuning encoder causes the display to count up and down as normal but all
other buttons functions are frozen. Another strange symptom is the RF gain
adjusts the noise level up and down but the AF gain control has no effect.
I do have a working rig but am not willing to risk it by swapping the logic
cards at this point. I will use it for making measurements of what is normal
as a point of reference.
I know there was quite a bit of discussion as recently as a year ago on this
subject, based on a search of the archives, but never any indication of a solid
determination of the pattern failure. I'm sure what is failing on the boards
is common to most all of the routine failures...those not related to lightning
or other external factors.
Any info you would be willing to share would be much appreciated...
Thanks
Cecil Acuff
K5DL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|