just wondering,
what was the reason, if any, that Ten Tec sent the radio back as un-repairable?
lighting hit?
can of pop spilled inside?
Joe ham and his new soldering gun had a try?
just wondering....
mike, wb8vge
On Sep 3, 2012, at 9:55 AM, chacuff wrote:
> Thanks Clayton,
>
> He was on my list of folks to contact since he was involved in the
> discussions a year or so ago.
>
> Not sure if he will want to share too much of the secrets he might have
> discovered....:-)
>
> Cecil
> K5DL
>
> ----- Original Message ----- From: "Clayton Brantley" <clayton_n4ev@yahoo.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, September 03, 2012 7:41 AM
> Subject: Re: [TenTec] Omni VI Logic board
>
>
> Cecil: There is a guy near Greenville, SC that works on those things among
> other radios.
> You might try an email to glenn@dsmlabs.com and see what he says. He does
> have a
>
> few of the Omni rigs for test jigs.
>
>
> 73 Clayton N4EV
>
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|