I meant 30M receive :-)
----- Original Message -----
From: "Curt" <rhulett1@consolidated.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, September 19, 2012 1:45 PM
Subject: Re: [TenTec] question about the omni c #546
Dale,
Visit here
http://www.tentec.com/pages/Identifying-the-Omni-D-series-A%2C-B-or-C.html
to see the various models described. The Omni C was the last in the
series. I own one (which is not for sale ), and have 30M & 12M. I've
never added 17M because there were lot of posts back in the day about 17M
being not advised because of spurs generated by the mixing scheme.
The Omni D version B ( which I once owned ) produced before WARC had 10M
receive and offered a kit to add WARC, of course those kits are
unobtanium.
Hope this helps.
73 & GL Curt KB5JO
----- Original Message -----
From: <yash@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, September 19, 2012 11:02 AM
Subject: [TenTec] question about the omni c #546
?????? Have been reading the info? that I could fine on the OmniC 546.
Some sites say the later versions of the rig were set up or included the
WARC bands. If this is true ,was there a model change? or all the same.
If some one has a c with the Warc bands , Please get back . I would
consider buying the rig.
thanks
dale wt4t
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|