I have a 566, and the knobs are perfectly balanced.
You can push on the sliver apron to adjust knob friction -- I have mine set
to minimum.
You can also take them off and re-set the setscrew. You can remove and
re-adjust and clean the rubber giant "O" ring that you grab on to turn it.
I also have the remote knob, and it is also velvet smooth.
Visitors to my shack are amazed at how nice the 566 feels and shows and
performs; one ham said "I didn't know Ten-Tec made stuff like this!"
-Mike K3MC
On Mon, Sep 24, 2012 at 3:27 PM, shristov <shristov@ptt.rs> wrote:
>
> Has anyone suceeded in balancing Orion 565 VFO knobs?
>
> On my Orion 565, both VFO knobs (when left to themselves) return
> to the same angular position, which is precisely the same on both encoder
> shafts.
>
> I'd guess this means that VFO knobs are actually cast unbalanced,
> and no attempt is made to balance them later.
>
>
> 73,
>
> Sinisa VE3EA, YT1NT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|