Hi All
New here... hope to meet fellow TT ops OTA soon.
Just got my 562 Omni V back from TT Service for relay replacement. Had it
on the air for about 4 hours... all was great...went to bed... came out the
next day, began to tune up on 75m, was tuning fine, then all of a sudden, I
had close to 200 Watts of power, high swr (where before all this started,
the swr was around 2:1), and oddly, the RF pot didn't change the RF output.
I cut it off and have not pursued it yet. Could this be an issue with the
new relays? Just thinking out loud... I understand there is an 'unspoken'
thing about the PA in the Omni V where if you use the 962 TT PSU, there is
over-current system that will shut it down before anything happens. I
unfortunately don't have that luxury, with an Astron RS35M. Could this have
been prevented with the 961 or 962 PSUs?
Any ideas on what happened?
Thanks es 73
Josh // W4ZZK
Sent from Droid X Mobile with MIUI...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|