TenTec
[Top] [All Lists]

Re: [TenTec] Microphone Wanted

To: "Rodney" <w3krq@dejazzd.com>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Microphone Wanted
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 16 Jan 2013 15:37:56 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
While the 708 and 709 do have the same electrical specs, the 708 is omni directional while the 709 is unidirectional. A mike with a omni directional pattern typically will pick up sound from the front, sides and back equally while a unidirectional mike picks up from the front only. With radios, amps, power supplies, computers and such on the desk, those most likely behind the mike, then those sounds are also picked up more so by the omni directional mike but not the case with the unidirectional mike. Should one have a quiet room then either will work satisfactorily. If ones room is plagued with noises then the unidirectional mike choice is better.

Just this morning I worked a station that had a S-9 +20 dB signal on voice but between words his signal was S-9. This was due to amp noise producing a roar in the background. I inquired as to the processing being used and he indicated that it was off. One other station suggested he reduce his mike gain and get closer to the mike. He did and his audio was wonderful. The correct mike along with good mike technique and proper gain adjustment typically makes wonderful improvements to audio quality.

73
Bob, K4TAX




----- Original Message ----- From: "Rodney" <w3krq@dejazzd.com> To: <rmcgraw@blomand.net>; "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, January 16, 2013 1:32 PM
Subject: Re: [TenTec] Microphone Wanted


I agree 709a great mike for the money.

-----Original Message----- From: Robert Mcgraw Sent: Tuesday, January 15, 2013 8:44 PM To: Ed Purvis ; Discussion of Ten-Tec Equipment Subject: Re: [TenTec] Microphone Wanted
The 709A is a better sounding mike.

73
Bob, K4TAX

Looking for suggestions on a mic for my OMNI V.  Leaning toward a 708
desk mic. I used one on a Paragon II at one time.  Also would like
suggestions on a hand mic.
If you have a clean 708 for sale, please write back in a private e-mail. Details and price in first reply, please.

Thanks,

Ed WA4NJY
Bradenton, Fl


Official it getter.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>