I want to thank Alan N8FL, John KC2QMA, Rick N4ASX and Bill N8OP, for securing
7.260 for us yesterday. When I came into my hamshack at 19:50 UTC, these guys
were holding down 7.260 and I decided to join them and by 20:00 UTC net time, I
had already checked in 25 stations.
There was a total of 83 people who checked into the 40 meter net yesterday.
Obviously there were others who tried and could not be heard. We had other
stations with large wire antennas listening for any weak stations and the total
above also reflects ones that were relayed to me by Lloyd N2KPC. Yes, we always
ask for relays!
The 20 meter net followed at 21:00 UTC on 14.325 and 86 people checked in.
Again, obviously from many emails I received, there were others who were
calling and could not be heard. Again, we had several stations with large
antennas and directional beams that were panning from WEST to NORTHWEST to
NORTH, to NORTHEAST and EAST and the number above reflects those that I heard
and others that were relayed to me.
Because of propagation, smaller antennas and running barefoot, certain people
could not be heard and I feel very bad for those and wish that there was a
solution.
The TEN-TEC 40 meter and 20 meter SSB nets are experiencing growing pains right
now and we are taking into consideration a multitude of suggestions that reach
my email and it usually comes right after the nets are over each Sunday.
To favor one person, group or area usually offends some other person, group or
area. We have attempted to be fair to everyone on both nets. There is no
contest here, there is no favortism being shown to anyone or group or area.
My question is, where have all the TEN-TEC users been the past few years
without a TEN-TEC net? Who have they looked to for technical help? These are
simple and fair questions for me to ask. I am probably one of the newest
TEN-TEC radio owners (March 2012) and when I contacted many about the TEN-TEC
net, I was told that it was abandoned several years ago because the net control
took a job at another radio company. I was shocked to hear that there wasn't
any TEN-TEC net.
As the former net control for the Yaesu FT-2000 net for several years, where I
would check in several hundred people each net, I decided to ask some of the
TEN-TEC users to get together and this is how I became net control of the
TEN-TEC nets in April 2012.
No one else came forward to take it and Jim Wharton NO4A Vice President TEN-TEC
INC. told me to take the net and be the new net control in April 2012.
The certificate program was Jim Wharton's idea and I agreed to take on the
added responsibility of compling a Data Base for the certificate program. This
is not a contest or a gimmick, this was initiated by Jim to reward TEN-TEC
operators for their continued support of their products and I fully agreed with
him.
Next item to be addressed: When I start calling for specific CALL AREAS, I am
going to ask if anyone has a question or problem with a TEN-TEC product. If and
when anyone responds, I will find out who can help them and have them go to
another frequency and to return when they are finished. Some may say that this
is not fair, but I say that this is expedient for the rest of the group that
wants to check in.
To those who are experiencing a problem, there are several avenues to proceed
with. The best place is to post the problem on any of the 4 Yahoo TEN-TEC
Groups, where a multitude of operators are ready to respond with assistance.
They can also contact Bob K4TAX, who is very erudite when it comes to TEN-TEC
radios. Bob is also a BETA TESTER for TEN-TEC. They can also contact John
Henry, TEN-TEC engineer or other tech support specialists at the TEN-TEC
company. Thank you for your time, consideration and support.
http://www.qrz.com/db/k3ur
John D. Occhipinti, K3UR
Net Control, TEN-TEC SSB Nets
http://k3ur.com
The Voice of Atlanta
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|