TenTec
[Top] [All Lists]

Re: [TenTec] eagle

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] eagle
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 11 Feb 2013 18:32:05 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
And of course I missed the later info that there's a fixed 2.4Khz dsp
filter preceding the roofing filter.  So it's hard to believe that the
change in roofing filter would make much of a difference.

73,
Barry N1EU

On Mon, Feb 11, 2013 at 6:18 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:

> I just took the time to read through the Eagle manual.  Much to my
> surprise, the spec section seems to indicate that ssb tx bandwidth IS
> determined by the roofing filter.  So yes, changing the roofing filter from
> 2.4Khz to 2.8Khz should have a direct effect on the tx audio.
>
> 73,
> Barry N1EU
>
>
> On Sun, Feb 10, 2013 at 9:24 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
>> Is that filter is in the tx signal path of the Eagle?  The tx signal
>> isn't filtered entirely in dsp with configurable bandwidth?
>>
>> 73,
>> Barry N1EU
>>
>>
>> On Sun, Feb 10, 2013 at 4:04 PM, Rodney <w3krq@dejazzd.com> wrote:
>>
>>> I got a 2.8 filter from inrad  for my Eagle  got great audio reports.
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>