Re: [TenTec] eagle

["Bob McGraw - K4TAX" <RMcGraw@Blomand.net>]

Was that slot configured for 2.4 KHz or 6.0 KHz?  If 6.0KHz, did you leave 
the 2.4 KHz in the original slot and how was that slot configured?
I'd like more detail as to what filter is actually in F1, F2 and F3 slots 
and how are they defined in the CONFIG menu.
Thanks

73
Bob, K4TAX


----- Original Message ----- 
From: "Rodney" <w3krq@dejazzd.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, February 11, 2013 12:21 PM
Subject: Re: [TenTec] eagle


> I installed the filter in the am slot did a a/b test on 40m with 4 hams got 
> better audio with 2.8 than 2.4.
> -----Original Message----- 
> From: Barry N1EU
> Sent: Sunday, February 10, 2013 4:24 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] eagle
>
> Is that filter is in the tx signal path of the Eagle?  The tx signal isn't
> filtered entirely in dsp with configurable bandwidth?
>
> 73,
> Barry N1EU
>
> On Sun, Feb 10, 2013 at 4:04 PM, Rodney <w3krq@dejazzd.com> wrote:
>
> > I got a 2.8 filter from inrad  for my Eagle  got great audio reports.
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec