i found a used ameritron 70 amp power supply more than enough and im running
the omni 6 with it!!
bob k0tz
all things are possible in Christ Jesus our savior
--- On Sun, 3/3/13, Bob McGraw - K4TAX <RMcGraw@Blomand.net> wrote:
From: Bob McGraw - K4TAX <RMcGraw@Blomand.net>
Subject: Re: [TenTec] Herc II vs Astron
To: "Tom Macon" <tmacon@wi.rr.com>, "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Date: Sunday, March 3, 2013, 11:28 AM
You will likely need to add blocking diodes in the output line of each supply.
Then you will need to raise the voltage of each supply to offset the drop of
the diodes. Be sure the leads from each supply, both negative and positive are
precisely the same length, connected to a common point, such that the R value
of each lead is exactly equal in terms of R value. Each supply will need to be
adjusted at rated load to exact voltage thus each supply delivers 13.80 volts.
Any unbalance will be seen as burden on any other supply. Thus it may shut
down due to the current limit circuit.
I can be done, but must be done very carefully and accurately.
73
Bob, K4TAX
----- Original Message ----- From: "Tom Macon" <tmacon@wi.rr.com>
To: "Ten-tec Forum" <tentec@contesting.com>
Sent: Sunday, March 03, 2013 11:19 AM
Subject: [TenTec] Herc II vs Astron
> Hi, all -
>
> I have replaced the four supplies in the 9420 beast with four Astron
> SS-25's. At first all seemed well but then I experienced reduced power out
> from the 420 Herc.
>
> Upon investigation, it seems that one or more of the Astrons shuts down so
> not all four sections of the amp are powered. I see that, if I turn off one
> supply, that there is backfeed from the amp showing up on its output. My
> guess is that the one of the supplies (a little slower to come up?) senses
> the backfeed voltage from another one and this triggers some protection
> feature.
>
> I have only the sheet that came with the Astrons - no schematic or detailed
> technical info. Tomorrow I will call them to see if they can shed any light,
> meanwhile perhaps someone here has experience or insight?
>
> 73,
> Tom Macon, K9BTQ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|