Although I had my CORSAIR-II display rebuilt at the electronic shop at work
in the late nineties (I caused the problem to begin with) I've found the
display periodically needs to have ALL connections from the display and
frequency counter removed and reseated one at a time after wiping each
connector pin with a Q-tip dampened with Cramolin or DeoxIT Gold. If the
clean-up does NOT work, then the likely culprits are the electrolytics and
possibly the transistors of the display driver. The best thing to do is just
replace them all with new high quality parts. There's nothing special that
cannot be replaced by a local tech with a steady hand, good technique, and
good eyes.
I find my Corsair-II display seems to work better when used frequently -
every day. There was a time when I turned it on just a couple times a year
(Field Day) and had to clean the display contacts before the operation. Now
I use it daily for digital operating and its like every five years for
cleaning the connectors. YMMV.
73 ES DX,
Gary -- AB9M
-----Original Message-----
From: Stan Barr
Sent: Sunday, March 10, 2013 3:03 AM
To: mw1lcr@elsasystems.co.uk ; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Corsair II Display Segments
On 10/03/13 02:16, Adrian Rees (MW1LCR) wrote:
Hi all
I have just acquired a Corsair II, and am very impressed with it so,
far. However, in two of the 7 segment displays, the LED's are not
lighting. If you think about the digits 2 and 3, its the bottom segment
in each of them, and in the Tens and Units of MHz.
I am guessing the problem will be either a dodgy connection, or similar
dry joint type of affair. The previous owner has replaced a number of
electrolytic capacitors in the display, FWIW.
Apart from the dodgy connection / dry joint is there anything else I
should consider ?
Mine suffers from this about every 12 months or so. A poor contact
on the display connector is the culprit (in my case anyway) some
contact cleaner cures it for a while.
--
Cheers and 73,
Stan Barr G0CLV GQRP-3369 FISTS-667 g0clv@dsl.pipex.com
"Never leave well enough alone." - Raymond Loewy
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|