Re: [TenTec] TenTec Digest, Vol 129, Issue 1

["Pfizenmayer" <pfizenmayer@q.com>]

I had virtually the same problem but mine was that it shut off the line out 
audio
so my RTTY/PSK did not work. Drove me nuts chasing that one down .

Also once in a while - it would put put a nice clean  1 v pp
sine wave in audio range out of line out.

Hank K7HP


> Message: 1
> Date: Sat, 31 Aug 2013 13:18:37 -0500
> From: Mike Chatfield <mikechat@embarqmail.com>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Subject: [TenTec] Orion II SAF issue when left on and power down then
> power up
> Message-ID: <5222337D.8080804@embarqmail.com>
> Content-Type: text/plain; charset=ISO-8859-1; format=flowed
>
> I am running version 3.033xa just installed a couple of days ago. I
> noticed an interested problem with the SAF.
> If I leave SAF (Main Receiver) on and power down, then bring the Orion
> II back on I get NO receive audio (mostly just popping noise) on the
> Main receiver. In order to get the audio to work I must shut off SAF
> then do a power cycle, it works fine then.
> As long as I remember to shut off the SAF BEFORE powering off everything
> works fine.
> As anyone seen this issue?
> Not a big deal but it looks like a firmware issue...