| To: | Orion565 <orion565@yahoogroups.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Dim LEDs on Orion front panel |
| From: | Barry N1EU <barry.n1eu@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 3 Oct 2013 15:49:01 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
The LEDs illuminating the ANT and VFO switch matrix are VERY dim, essentially impossible to see. Before I tear into my Orion 565, I was wondering if anybody else has previously troubleshot this exact issue. I suspect either impaired connector conductivity or a bad cap. But has anybody already done this deed and can report their findings? Thanks & 73, Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] ALC issue on Corsair II, IV3YNB op. Matteo |
|---|---|
| Next by Date: | Re: [TenTec] Dim LEDs on Orion front panel, Rick - DJ0IP / NJ0IP |
| Previous by Thread: | [TenTec] ALC issue on Corsair II, IV3YNB op. Matteo |
| Next by Thread: | Re: [TenTec] Dim LEDs on Orion front panel, Rick - DJ0IP / NJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |