TenTec
[Top] [All Lists]

Re: [TenTec] 160 M antenna

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 160 M antenna
From: "resluder@yahoo.com" <resluder@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 08 Nov 2013 22:02:20 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Rick,

You nailed my situation to the tee.  I live on a 1/2 acre and wish it was an 
acre.  If I had a true 1/2 acre meaning no house I would be okay on 160.

Hams always want more :-)

Eric
W9WLW
http://w9wlw.blogspot.com/

Rick - DJ0IP / NJ0IP <Rick@DJ0IP.de> wrote:

>Let's not forget that we're talking about  1 6 0  meters here.
>
>Of course 38 Ohms radiation resistance would be a great antenna but the
>reality is, the vertical antennas most people deploy on that band are more
>in the neighborhood of 10 Ohms (at best).  The ground loss raises the
>impedance high enough to fake the OM into believing he has a good antenna
>because the SWR is not too bad.
>
>It is not difficult to build an effective antenna on 160m when you have the
>space for the radials, even if you can't go so high with the radiator.  You
>just need to use a lot of wire above the earth.  Run the vertical section as
>high as you can and then use 4 top-hat wires.  Then you will have a great
>signal, provided you have a decent radial network below the antenna.
>
>Without tricks, in order to have 38 Ohms on a 160m vertical, it would have
>to be 132 ft. high and have about 60 radials under it.  I doubt that more
>than 2 or 3 people here have ever had or even used something like that.
>I sure haven't.
>
>The bottom line is, if you don't have at least a half acre of land, you're
>probably never going to have a big signal on 160m.  With an acre, it's no
>problem.
>
>73
>Rick, DJ0IP
>
>
>-----Original Message-----
>From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Stuart
>Rohre
>Sent: Friday, November 08, 2013 9:17 PM
>To: tentec@contesting.com
>Subject: Re: [TenTec] 160 M antenna
>
>No one listening to the 38 ohm antenna will be able to tell the difference
>in signal level from a 50 ohm antenna.  There is way more variability in the
>inonosphere than that small mis-match.  Save your time for operating!!
>Gud DX, try 10!
>Stuart Rohre
>K5KVH
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>