I measure 4.63V on both tuning encoders. And both encoders work on the A
cable, so it doesn't seem like that would explain it. But I'll poke around
the A9 board. I replaced all the A9 capacitors a few months ago.
Thanks & 73,
Barry N1EU
On Sat, Jun 21, 2014 at 5:23 PM, shristov <shristov@ptt.rs> wrote:
>
> Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> > Thanks Sinisa. vfoB would not tune at all.
>
> I had the same problem. VFO B encoder had a supply voltage of only 4.66 V.
> After tightening 4 fixing screws on the A9 board, the voltage at encoder
> rose to 4.77 V
> and it started workig.
>
> 73,
>
> Sinisa
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|