TenTec
[Top] [All Lists]

Re: [TenTec] Source for TITAN 425 plate choke?

To: "'Dave Bowker'" <david.bowker@yahoo.com>, "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Source for TITAN 425 plate choke?
From: "Jerry Haigwood" <jerry@w5jh.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 17 Jul 2014 17:11:29 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hi All,
    Has anyone mentioned that MFJ sells the Plate Choke they use on their
amps?  The plate choke uses a ceramic form 1 inch diameter and 5.5 inch
long.  It has three connected coils to break up resonances and appears to be
very well made.  I have one but I don't remember what the cost was.  I think
it was about $30.

Jerry W5JH
"building something without experimenting is just solder practice"

-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Dave Bowker
via TenTec
Sent: Wednesday, July 16, 2014 2:11 PM
To: tentec@contesting.com
Subject: [TenTec] Source for TITAN 425 plate choke?

The first thing I recommend is determine why the existing choke failed. 
Unless you correct the cause, the effect will be the same with a replacement
choke, no matter who the mfr/supplier is.


73, Dave, K1FK
Fort Kent, ME
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>