TenTec
[Top] [All Lists]

Re: [TenTec] TenTec Items FS

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] TenTec Items FS
From: "Merschrod" <kris@merschrod.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 22 Aug 2014 02:40:33 +0500 (GMT-5)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Ken I am interested in the "Switcher / 25" How about $140 shipped to me in
the 14850 zip code ?

Kris

>
> TenTec "Scout" Accessories, Power Supplies, RF Speech
> Processor, Communications Speakers, Coaxial Antenna
> Switches, Noise Filter, AC Line Voltage Meter, Low Pass
> TVI Filters, Bird Wattmeter, and other miscellaneous
> accessories For Sale:
>
>
> Band Modules for TenTec 555 Scout / 556 Argo:
>
> These band modules are used with the TenTec Model 555
> "Scout" HF transceiver, and also with the TenTec Argo
> Model 556, low power HF transceiver. They plug into the
> transceiver to give coverage of a single band.
>
> Band modules are available for 80/75 meters, 20 meters,
> and 15 meters.
>
> They are $55 each, or buy all three for $160.
>
>
> TenTec 234 RF Speech Processor
> The 234 is the predecessor to the 715 speech processor
> except it matches the early Omni Series A, B, and C rigs,
> and others of that era.  It has both a 4 pin plug and a
> 1/4 inch stereo jack for input.  It needs 13 V DC at low
> current.  It is an extremely effective unit, typically
> providing about a 6 db increase in talk power.
> With paperwork for $150.
>
>
> APC "Pro 7" Noise Filter and Surge Suppressor:
>
> This unit has 7 outlets, with a 6 foot cord, and provides
> surge suppressor for your equipment. It also provides
> noise filtering / EMI / RFI suppression of 60 db. There
> is $75,000 worth of insurance included. It comes with a
> lifetime warranty, and I think this is APC's "Top of the
> line" unit.
>
> Detailed specs can be found at
> http://www.apc.com/products/resource/include/techspec_index.cfm?base_sku=PRO7
>
> This one appears to be new, unused, in its original box.
> Only $18/
>
>
> TenTec Switching Power Supply:
>
> "Switcher / 25" 25 amp switching power supply:
> This is a 25 amp switching power supply in a case that
> matches the early Omni series case, with the metal bezel
> around it. It is in a case that is the same size as a 243
> remote VFO. It has an ammeter on the front, along with
> Switch, TenTec logo, and output bulb. The front panel
> basically looks like a 280 power supply with a metal bezel,
> but says "Switcher/25" on it. It is very quiet, and well
> shielded, and does not produce any electrical noise that
> I could find. $140
>
>
> Kepco Variable Bench Power Supply:
>
> This is an ideal bench power supply! It is a Kepco Model ABC
> 40-0.5, which means that it will produce from zero up to 40 V
> DC at up to 1/2 amp. Great for the bench.
>
> The voltage is adjustable with a 10 turn pot from close to zero,
> up to about 40 volts. There is a fairly large analog meter that
> reads the voltage. There is also current limiting built in that
> is adjustable from about 100 ma to up to about 700 ma. The same
> meter that reads voltage can be switched to read current, or
> short circuit current (the point that the current limit is set).
> In addition, there are connections on the back to allow remote
> sensing and remote programming. This is a quality regulated
> power supply!
>
> This particular unit works 100%, and looks extremely nice. $85
>
>
> Low Pass TVI Filters:
>
> A low pass TVI filter is added to the transmitter to reduce
> harmonic interference. All have SO-239 connectors and are 50
> ohm filters.
>
> Johnson 250-20
> This cylindrical low pass filter has a cut off frequency
> of 45 MHz and 75 db of attenuation, and is adjustable.
> Rated at 1000 Watts AM, or 5000 Watts PEP SSB.
> The fact that it is adjustable, means you can get rid of
> more TVI, and it is rated to handle higher power than most.
> A real win-win situation. $30 or with mounting bracket, $35.
>
> B & W 425 (same as FL-10/1500)
> Cuts off just above 10 meters, and handles 1500 Watts.
> Newer case style, $30.
> Older, heavier copper style case, painted gray. $35
>
> Para Dynamics PDC 1089
> This filter is rated at a full Kilowatt, up to 30 MHz.
> 5 x 6 x 2 inch black box, instead of the long enclosure.
> $25
>
>
> Coaxial Antenna Switches:
>
> All work fine, look fine, and use SO-239 connectors.
>
> B & W Model 550 A Coax Switch
> This model will switch up to 5 antennas, and does NOT
> ground unused antennas. Coax comes out the side, like
> spokes of a wheel.
> It will handle the full legal limit. $35
>
> SCP Comm Switch SC-40-AS Coax Switch
> Three position antenna switch in rectangular box.
> Connectors on the back. In original box. May be new. $25
>
> Two position "Strip Line" Coax Switches:
>
> These switches utilize metal cavity construction for max efficiency
> and high isolation. Isolation is better than 50 dB at 300 MHz
> with low insertion loss less.
> All are two position and are typically rated for 2500 W PEP,
> and good to 600 MHz.
>
> Diawa CS-201 - $22
> Opek CX-201 - $22
> MFJ 1702 C - With center position that grounds both antennas,
> and added lightning protection. $25
>
>
> Bird 43 Watt Meter:
>
> The Bird 43 is an insertion type RF watt meter, designed
> to measure RF power and load match in 50 ohm coaxial
> transmission lines. It is intended for use with CW, AM,
> FM, and TV modulation. It measures power from 100 mw
> to 10KW, depending on the element used. The meter provides
> direct readings in watts with an expanded scale for easy
> reading. The scale is graduated for 25, 50, and 100 full
> scale. Elements are available in a variety of power, and
> frequency ranges.
>
> This particular meter is model 4300.21 manufactured in
> March 1957, so it is the older, well constructed model.
> It has "N" connectors, with the leather handle, which
> is in good shape.
>
> The meter works well. $175
>
>
> Communications Speakers:
>
> Realistic 21-549 A
> This speaker is about 4 inches square and about 2 inches
> deep. It is rated for 5 watts, has an 8 ohm impedance, and
> is listed as a 300 to 3000 Hz frequency response, making it
> ideal for communications. It has a 3.5 mm (1/8 inch) mono
> plug, as used by most modern rigs. Gimbal mount included.
> It is black in color, looks great, and sounds great. $12
>
> Vanco SPB-5
> Appears to be the same at above, but with a Vanco label.
> Also includes gimbal mount. $12
>
> Vanco SPB-6
> Similar to SPB-5 above, but is considered a noise
> cancelling speaker. 10 Watt rating. Still in original
> box, new. $18
>
>
> Cables for CW keyers and keys:
>
> Cable for paddles
> About 3 feet long, and with a 1/8 inch (3.5 mm) stereo
> connector on the end, like used by most rigs. $8
> As above, but 1/4 inch plug. $8
> As above, with GOLD 1/4 inch plug.  $15
>
> Cable for straight key
> About 3 feet long, with a mono 1/8 inch (3.5 mm) phone
> plug on it, as used with a straight key. $5
> As above, but 1/4 inch plug. $5
>
>
> I also have many other accessories available such as many
> different types of microphones, HTs, VHF and UHF rigs,
> antennas, etc. Just too many things to list here.
> Please e-mail your requests.
>
>
> Prices do not include shipping from Florida.
>
>
> Thanks.
>
> 73,
>
> Ken, W8EK
>
> Ken Simpson
> E-mail to W8EK@FLHam.net or W8EK@arrl.net
> Voice Phone  (352) 732-8400
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>