We've been down this road before and I don't agree on the specific need for
a highly accurate freq counter to perform a BFO oscillator alignment. A K3
or Orion gc receiver aligned to WWV and tuned to 9MHz does a fine job.
73, Barry N1EU
On Sun, Oct 19, 2014 at 8:23 PM, Mike Bryce<prosolar@sssnet.com> wrote:
Absolutely!
No one that I know can do that ‘by ear’
I have some rather high zoot equipment here on my workbench, but it’s
hasn’t been calibrated in a long time. Decades perhaps? I don’t know. but
for me, it’s good ‘enuff for what I do. If I’m off a few hertz, I can live
with that.
Having one frequency counter is okay.
Have two?
They’ll never be on the same frequency.
Mike Bryce WB8VGE
prosolar@sssnet.com
On Oct 19, 2014, at 3:23 PM, Wade Staggs<tvman1954@gmail.com> wrote:
*Amen and 100% agreement on your statement Bob. A workman is only as good
as his tools. Although when I was younger, about anything on my 1957
Chevy
could be fixed with Vise grips and a Clothes Hanger. Try that today!*
* 73 Bob
from Wade/KJ4WS*
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec