I would try a full reset and then see if the update could be done.
Here's the full reset procedure.
1) Power off Orion.
2) Power On holding the VFO B LCK button.
3) Continue holding LCK button until the radio says "Battery Failure".
4) Power off Orion.
5) Power on holding "Main RX/TX" button.
6) Continue holding this button until the radio says reset complete.
7) Do not clear any settings when asked to do so.
8) Power the Orion off and back on one more time.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 6/28/2015 9:41 PM, Ron Castro wrote:
Bob:
I'm sorry to hear about the problem with your Orion II reprograming. This is
one area where I would have to ask the experts on the Ten-Tec reflector, and I
am forwarding a copy of your email to them. They should be able to give you an
answer to your problem. I will forward any replies to you.
73, es GL
Ron Castro
N6IE
www.N6IE.com
Member:
ARRL
Redwood Empire DX Assn.
Northern California Contest Club
Northern California DX Foundation
Society of Broadcast Engineers
-----Original Message-----
From: bob-on4ldl [mailto:robmichaux@voo.be]
Sent: June 27, 2015 11:54 AM
To: ron@n6ie.com
Subject: infos
hello Ron
I search information on TENTEC Orion II 566 AT especially the technical manual
I explain, making the updated firmware I had a power outage ( alternative
courant schutdown ) I try reprogrammed correctly updated firmware and here are
the symptoms
Test update with 2 differents PC and differents cables without any result ,
port com OK
Update start very slowly and after about 10 minutes windows give "
windows update can't continue to run"
For information during last update a power shut down appear and upgrade stopped
before complete process .
Have you idee about this issue ??
Wait for your answer
Or I want a procedure to put it into state Tentec setup AT 566 Orion Program
Best regards
Robert ON4LDL - Amateur radio enthusiast Tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|