TenTec
[Top] [All Lists]

Re: [TenTec] TenTec Digest, Vol 156, Issue 4

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] TenTec Digest, Vol 156, Issue 4
From: "rick@dj0ip.de" <Rick@dj0ip.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 8 Dec 2015 18:42:21 +0100
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
WE retired OM appreciate your contribution!

73
Rick, DJ0IP

-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Paul
Christensen
Sent: Tuesday, December 08, 2015 3:26 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] TenTec Digest, Vol 156, Issue 4

What?  Work for a living?  You and I are certainly in the minority. 

Paul, W9AC 

Sent from my iPhone6

> On Dec 8, 2015, at 8:58 AM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> 
> I can but it will have to wait till after work today.
> 
> 73, Barry N1EU
> 
>> On Tue, Dec 8, 2015 at 8:44 AM, Paul Christensen <w9ac@arrl.net> wrote:
>> 
>> Barry,
>> 
>> Can you measure the Flex 6500 at say...a 2.8K filter setting?  I know 
>> this not a normal CW bandwidth for contesting but it would be helpful 
>> to see what timing changes have evolved since my last measurement.
>> 
>> Paul
>> 
>> -----Original Message-----
>> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of 
>> Barry N1EU
>> Sent: Tuesday, December 8, 2015 8:42 AM
>> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>> Subject: Re: [TenTec] TenTec Digest, Vol 156, Issue 4
>> 
>> I just measured 170msec latency on the 6500 in cw receive.  It's a 
>> lot (too much for serious contesting IMHO) but it's not 350msec.
>> 
>> My methodology was to transmit a single dit using another rig and 
>> used a microphone/soundcard to record the tx sidetone of rig 1 and 
>> then the received dit on rig 2.
>> 
>> For comparison, my Orion II measured 45msec and my ANAN-100D SDR 
>> 70msec for cw rx latency.
>> 
>> 73, Barry N1EU
>> 
>>> On Mon, Dec 7, 2015 at 8:23 AM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>>> 
>>> I will personally measure the latency of the Flex 6500 and get back 
>>> to you.  I'm not believing 350msec at this point.
>>> 
>>> 73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>