http://www.tentecwiki.org/doku.php?id=565pwrdistfail
On Tue, Dec 8, 2015 at 2:31 PM, Kimberly Elmore <cw_de_n5op@sbcglobal.net>
wrote:
> I found it on the TenTec Wiki at 565pwrdistfail - TenTecWiki. There are
> variants, but Barry's was the the most recent.
>
>
> | |
> | | | | | |
> | 565pwrdistfail - TenTecWikiDetailed analysis by K7HP of the 81936 A9
> Power Distribution Board - Orion 565 and Orion 566 OII (scroll down for
> latest advice) (posts from the Ten-Tec and Orion Reflectors) April 6, 2007
> |
> | |
> | View on tentecwiki.org | Preview by Yahoo |
> | |
> | |
>
> Kim N5OP
> From: Froiseth Richard <Rfwd6dok@centurylink.net>
> To: Kimberly Elmore <cw_de_n5op@sbcglobal.net>; Discussion of Ten-Tec
> Equipment <tentec@contesting.com>
> Sent: Tuesday, December 8, 2015 1:16 PM
> Subject: Re: [TenTec] How to Purchase Low-ESR Capacitors
>
> Where can I get Barry’s Cap list?
> 73’sRich, WD6DOK
>
>
>
>
>
>
>
>
>
> On Dec 8, 2015, at 10:41 AM, Kimberly Elmore <cw_de_n5op@sbcglobal.net>
> wrote:
> I just replaced all the electrolytics on my O II A9 board with the
> recommended capacitors researched by Barry, N1 EU. As I looked in the
> Mouser catalog, I began to wonder: how can I determine which capacitors are
> the "low ESR" type? It doesn't always seem obvious to me. Is there
> something I'm missing? Do I simply use the ESR filter and select the lowest
> available ESR for the value I want?
> Kim N5OP
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|