I have the following filters installed:
218 1.8 kHz 8 pole for SSB
220 2.4 kHz 8 pole for SSB
The third filter is not marked, but came from the factory.
73’s
Rich, WD6DOK
> On Mar 23, 2016, at 6:38 AM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> What are the three filters you have installed in the 9MHz i.f.?
>
> 73, Barry N1EU
>
> On Wed, Mar 23, 2016 at 8:11 AM, Froiseth Richard <Rfwd6dok@centurylink.net>
> wrote:
>
>> I am installing a INRAD SSB Roofing Filter in my Omni VI +.
>> Would it be better to hard wire the roofing filter, so it will be on at
>> all the times, or would it be better to turn the filter on using the N1 or
>> N2 switches.
>> I have SSB filters installed in the 9 MHz board at N1 and N2.
>>
>> Thanks in advance for your suggestions.
>>
>> 73’s
>> Rich, WD6DOK
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|