TenTec
[Top] [All Lists]

Re: [TenTec] OT: Question to the group

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OT: Question to the group
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 13 Jul 2016 22:50:52 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yes, ideally I'd want a bigger radio with a bigger screen and more knobs

If you go with the same form factor, please use a much higher resolution
than the 480x272 used in the IC7300.  If you did that, I think I'd actually
buy one at $1000 and 50W.

Barry N1EU

On Wed, Jul 13, 2016 at 10:25 PM, rick@dj0ip.de <Rick@dj0ip.de> wrote:

> Barry, that's not quite a fair criticism.  The radio is small so the
> screen must be small.  You can purchase optional software which replicates
> the screen onto any size computer screen that you please.
>
> As for the knobs, please explain what is missing or how many you might
> want.
> Tnx.
>
> 73 - Rick, DJ0IP
> (Nr. Frankfurt, Germany)
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Barry
> N1EU
> Sent: Thursday, July 14, 2016 12:11 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] OT: Question to the group
>
> I'm a big direct-sampling SDR fan but don't much care for the form factor
> of the IC-7300.  The screen is too small and not enough knobs.
>
> Barry N1EU
>
> On Wed, Jul 13, 2016 at 9:43 PM, rick@dj0ip.de <Rick@dj0ip.de> wrote:
>
> > What would you guys think of a new radio that had the following
> > characteristics:
> >
> > Ø   SDR radio with knobs, similar size and form factor to the IC-7300
> >
> > Ø  Superior receiver to the IC-7300; roughly on par with the Flex 6300
> >
> > Ø  50w of output power
> >
> > Ø  Cost: $1000
> >
> >
> >
> > I guess the big question is, is 50w a show stopper.
> >
> >
> >
> > Had someone ask me that question recently (obviously with the intent
> > to build this) and I had to pass.
> >
> > I dunno.
> >
> > For me I find it OK.
> >
> > I usually run my Eagle at 60w and when driving my amp, it runs at 60w.
> >
> >
> >
> > But my gut tells me most people won’t accept a 50w transmitter.
> >
> > They are programmed to expect 100w.
> >
> >
> >
> > What do you guys think?
> >
> >
> >
> > 73
> >
> > Rick, DJ0IP
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>