To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | [TenTec] Omni 6 5.5 MHz VFO PLL alignment |
From: | Dukes HiFi <dukeshifi@comcast.net> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Sat, 10 Dec 2016 12:07:42 -0600 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Now that I have repaired the PLL on the 5.5 mHz board of this Omni 6+ I am repairing, I need to align the loop IF amplifier and VCO centering. Is there a resource where I can find this process? Gary W0DVN _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] ten tec orion II power relay replacement, denton sprague |
---|---|
Next by Date: | Re: [TenTec] Omni 6 5.5 MHz VFO PLL alignment, Dukes HiFi |
Previous by Thread: | [TenTec] Filters available, Barry N1EU |
Next by Thread: | Re: [TenTec] Omni 6 5.5 MHz VFO PLL alignment, Dukes HiFi |
Indexes: | [Date] [Thread] [Top] [All Lists] |