TenTec
[Top] [All Lists]

[TenTec] TenTec HF Xcvr, NB, Mic, Speech Proc, PSs and more FS

To: TenTec List at contesting <tentec@contesting.com>
Subject: [TenTec] TenTec HF Xcvr, NB, Mic, Speech Proc, PSs and more FS
From: "Ken, W8EK" <kenw8ek@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 10 Apr 2017 17:55:47 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

TenTec Items For Sale:

Delta 580 HF Transceiver, Noise Blanker for 580 Delta,
Microphone, Speech Processor, Power Supplies,  etc.
.
.

TenTec Delta 580 HF Transceiver

The 580 Delta is a 100 watt output HF rig that covers
160 thru 10 meters, including the WARC bands.  Of
course it has the legendary TenTec full break in CW,
as well as great audio on SSB, and 100% duty cycle,
if needed.  Audio CW and SSB filtering is included,
and one can add an optional single crystal filter for
either CW or SSB.  It has a nice red LED read out.

This one works fine with full output power.  It has a
couple of very light scratches.  Paper work and power
cord included for $250.
.
.

TenTec 289 Noise Blanker for 580 Delta HF Transceiver

The 289 noise blanker is used with the 580 Delta.
To the best of my knowledge, it does not fit any other rig.
This one works fine, and includes paper work for $45.
.
.

TenTec 215 P Microphone

The 215 P mic is a high impedance microphone that
is used on many of the early TenTec rigs such as the
Tritons, Delta, Omni A, B, and C (both analog and digital).

This one works fine.  It has a regular cord (not a coiled
cord) with a 1/4 inch stereo plug. Base is not included.

With paper work for $55.
.
.

TenTec 715 RF Speech Processor

The 715 processor goes in the mic audio line to process the
audio. It converts the audio to RF, processes it, then
converts it back to audio. This is the most effective way
to produce good quality audio with extra "punch". It easily
gives about 5 to 6 to 8 DB extra punch.
It includes a bar graph, and other enhanced features.
A 15 volt DC wall wart is included to power it.

This one works fine and looks like new, with no
scratches. As far as I know, it was only opened to
confirm 100% operation.

With paper work for $190.
.
.

Astron Power Supplies:

All of these Astron power supplies have the same
features, but with different current capacities.
They provide 13 V DC for many ham rigs.
These are linear power supplies, so they will not
produce noise like the switching supplies.
All work 100%, and look very close to new.
Paper work is included.

Features:
Solid State Electronically Regulated
Fold-Back Current Limiting
Crowbar Over Voltage Protection
Heavy Duty Heat Sink
Input Voltage 105-125Vac
Output Voltage 13.8Vdc (internally Adjustable 11-15V)
Ripple Less than 5mV peak-peak (full load & low line)

RS-50 A
37 amps continuous, 50 amps ICS, $160

RS-20 M, with ammeter and voltmeter
16 amps continuous, 20 Amps ICS, $110

Pickup near Ocala FL is preferred for the power supplies
(especially the 50 amp!), but shipping is possible.
.
.

TenTec Model 48-15-800 "Wall Wart" Power Supply
15 V DC at 800 ma $15

.
.
I also have many other accessories from various manufacturers
available such as many different types of microphones, HTs,
VHF and UHF rigs, antennas, etc. Just too many things to
list here.
Please e-mail your requests.
.

Prices do not include shipping from Florida.
.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone  (352) 732-8400









.

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] TenTec HF Xcvr, NB, Mic, Speech Proc, PSs and more FS, Ken, W8EK <=