TenTec
[Top] [All Lists]

Re: [TenTec] 263 VFO will only transmit on receive frequency & will not

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 263 VFO will only transmit on receive frequency & will not work split
From: Mike Bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 4 May 2017 12:37:16 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
first thing I’d do is give the mode switch (in the remote VFO) a shot of deoxit


Mike, WB8VGE
www.theheathkitshop.com



> On May 4, 2017, at 12:33 PM, hmitchell3@comcast.net wrote:
> 
> I have a 263 VFO with my Corsair that works fine except it won't transmit on 
> the correct frequency when trying to operate split. The receive function 
> works well in all switch positions, just won't transmit on other than the 
> receive frequency. Does anyone have any suggestions on how to troubleshoot 
> this issue? Thanks, Harvey, K5YU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>