| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Century 21 audio hum |
| From: | Stuart Rohre <Rohre@arlut.utexas.edu> |
| Date: | Tue, 30 May 2017 16:11:43 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Do you have diode test function on your DMM? if so, you can inspect
each diode in a bridge in circuit, or at worst take off one lead from
Plus (+) bus. Silicon diodes will show 600 mv across each one,
germanium 300 mv. Make sure the capacitor following the bridge is
discharged before testing, and radio is unplugged from everything.
Stuart Rohre K5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Century 21 audio hum, Josh Gibbs |
|---|---|
| Next by Date: | Re: [TenTec] CORSAIR II TROUBLESHOOTING, ARDUJENSKI |
| Previous by Thread: | Re: [TenTec] Century 21 audio hum, Josh Gibbs |
| Next by Thread: | Re: [TenTec] Century 21 audio hum, Josh Gibbs |
| Indexes: | [Date] [Thread] [Top] [All Lists] |