TenTec
[Top] [All Lists]

Re: [TenTec] 961 power supply

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 961 power supply
From: Robert S Jenkins <qrp@kg4kgl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Jun 2017 09:44:32 -0400
List-post: <mailto:tentec@contesting.com>
Thanks Gary,

That is the sort of info I was looking for. I will check the rectumfrier to see 
if it is shorted. BTW, this supply does not have one big cap, but rather three 
10,000 uF caps.

Robert
KG4KGL



> On Jun 27, 2017, at 09:33, Dukes HiFi <dukeshifi@comcast.net> wrote:
> 
> They’re not that hard to repair.
> 
> You have three first choices. 
> 
> 1) The rectifier bridge is shorted - R and R
> 2) The big filter cap is shorted - R and R
> 3) The supply is putting out too much and the OVP is operating. This should 
> NOT pop the fuse though, this is a resettable SCR short that uses the current 
> limit to deny power.
> 
> This antiquated circuit is difficult to troubleshoot if the problem is not 
> one of the three things listed above. It is also sometimes even prone to 
> oscillation. I have one in my basement that worked fine under no load but 
> went into oscillation when the Omni 6 was turned on, in receive. It 
> eventually took out nearly all of the semiconductors on the PC board and is 
> now nothing but a parts mule.
> 
> Gary
> 
> W0DVN
> 
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>