TenTec
[Top] [All Lists]

Re: [TenTec] notch filter for Eagle?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] notch filter for Eagle?
From: Carl Moreschi <n4py3@earthlink.net>
Reply-to: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 20 Jul 2017 12:56:21 -0400
List-post: <mailto:tentec@contesting.com>
I have notch filters on all my radios and never use on on CW. The narrow passband filters for CW make notch filters unnecessary.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 7/20/2017 10:35 AM, Joe Papworth via TenTec wrote:
Quick poll:
How often do those on the list actually need or use your notch filters?

Most of my QSOs are CW contest QSOs.
Many times the bands are so crowded that a ginsu knife would come in handy and 
yet I rarely need the notch filter.

I'm just curious...

Later, Joe, K8MP

Sent from AOL Mobile Mail


-----Original Message-----
From: Dukes HiFi<dukeshifi@comcast.net>
To: Discussion of Ten-Tec Equipment<tentec@contesting.com>
Cc: Greg S<oldlongbeard@yahoo.com>
Sent: Thu, Jul 20, 2017 10:21 AM
Subject: Re: [TenTec] notch filter for Eagle?


Rick:

Since your SDR has notch inside the AGC loop, it must not be all that difficult 
to accomplish. Of course, I do not have sufficient knowledge of SDR designs to 
know how they manage AGC or notch functions.

Too bad no one is writing software for the Orion anymore. It would be nice if 
that change could be done. I might even buy one then...

I should have added the caveat in my remark regarding the relative uselessness of a notch 
filter outside the AGC line by saying “useless to ME”. Others are certainly 
free to believe that an external notch filter (that is, external to the AGC loop)  is equally 
effective (manual or otherwise).

This topic was beaten to death maybe 30 to 40 years or so ago when relatively decent 
external filters, such as the Autek and later on when DSP devices were introduced. 
They were pitched as offering Collins or Drake-like performance in otherwise mediocre 
receivers. They didn’t, but they did make operation less annoying to some 
degree. They also worked pretty well if you turned off the AGC and used the RF gain 
pot to compensate for variations in signal strength.

Gary

PS: Icom is the leader here in direct SDR, FOR ME. The performance is not there 
yet but I have zero interest in needing to have my PC on to run my radio. The 
7300 does not need a PC to work, the others do. They are headed in the right 
direction. If Ten Sec ever introduces a new radio, likely it will head in that 
direction too.

On Jul 20, 2017, at 7:08 AM,<a href="mailto:rick@dj0ip.de";>rick@dj0ip.de</a>  <<a 
href="mailto:Rick@DJ0IP.de";>Rick@DJ0IP.de</a>>  wrote:

notch

_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec"; 
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>