The jumper is the most likely root cause…
Gary
> On Aug 6, 2017, at 9:31 PM, Stan Gammons <s_gammons@charter.net> wrote:
>
>
> On 08/06/2017 09:21 PM, Dukes HiFi wrote:
>> Your 2.4 KHz filter COULD be bad but most likely the gain select is set for
>> a CW filter. The optional filter slots have a jumper select for added gain
>> when a CW filter is enabled, to compensate for insertion loss. If this is
>> enabled for the 1.8 KHz SSB filter, you will see what you see.
>>
>> Gary
>>
>>
>>
>
> Hi Gary,
>
> I doubt the 2.4 Kc or .5 Kc filters are bad. I have another 1.8 Kc and .5 Kc
> filter. Same results with either filters. I'll check the jumper.
>
> Thanks
>
>
> 73
>
> Stan
> KM4HQE
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|