Ethyl Alcohol will clean up circuit boards safely. You need to get one
of the brushes called "Acid brushes" which have a metal handle holding
bristles. Cut the bristles to only 1/4 inch from the ferrule, straight
across, to make the brush stiffer. Dip brush into alcohol and transfer
to board and gradually scrape off the green crud.
This may be a sign of someone using acid core solder, or storing circuit
board in a damp environment. On solder side of board, you may try
pre-brushing with a brass bristle brush, to loosen the green crud.
Good Luck!
Stuart Rohre
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|