Today I finally got around to replacing the crystal oven on my Omni 6+
Logic Board with a brand new oven. Not a bad job, but when I put the
Logic Board back in and started connecting everything, I ran into a
problem. Cable 41A has 3 pins and cable 34 has 2 pins. However, the
header that they mate with has 6 pins, one extra. I know I should have
noticed this when I took the board out, but I didn't. Now I'm confused
as to how to connect cables 41A and 34 back to the board. The schematic
in the manual is no help. Any help to un-confuse me would be greatly
appreciated. Thanks...Ken, K9PGC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|