I don't know if they are the same, but on my Omni VI the number 41A
connector is on the pins toward the front of the radio. Connector number
34 is on the rear pins with the single wire in the number 34 connector
connecting to the pin next to the 41A connector.
hth
73
Stan
KM4HQE
On 10/23/2017 04:51 PM, Ken wrote:
Today I finally got around to replacing the crystal oven on my Omni 6+
Logic Board with a brand new oven. Not a bad job, but when I put the
Logic Board back in and started connecting everything, I ran into a
problem. Cable 41A has 3 pins and cable 34 has 2 pins. However, the
header that they mate with has 6 pins, one extra. I know I should
have noticed this when I took the board out, but I didn't. Now I'm
confused as to how to connect cables 41A and 34 back to the board.
The schematic in the manual is no help. Any help to un-confuse me
would be greatly appreciated. Thanks...Ken, K9PGC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|