TenTec
[Top] [All Lists]

Re: [TenTec] Omni 6+ for sale (from last production run)

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni 6+ for sale (from last production run)
From: Byron Cordes <byroncordes@icloud.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 04 Feb 2018 12:22:15 -0600
List-post: <mailto:tentec@contesting.com>
Hi did you get my email about the Omni vi? If not here is my email
byroncordes@icloud.com.  I would like to but the old radio .
AC9PA 

Byron Cordes

> On Feb 4, 2018, at 10:00 AM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> 
> My Omni 6+ is looking for a new home.  This truly exceptional, one of a
> kind, radio has one minor issue that will need to be addressed by the new
> owner.  The receive signal has an intermittent slight loss in signal
> strength.  I know the issue lies somewhere after the front end board
> because it does not occur on the 9MHz IF signal.  So the new owner should
> be prepared to do a little troubleshooting.
> 
> 
> Now for the good news about this radio.  It is from the VERY LAST
> production run, serial number 08C10011 and is cosmetically in mint
> condition.
> 
> 
> 
> Other features:
> 
> 1.       optional trim ring has been added to the tuning knob
> 
> 2.       9Mhz IF output has been added using Clifton Labs buffer board (see
> http://omni6.wikidot.com/panadapt) - I've used it with an SDRplay RSP1
> (available with rig)
> 
> 3.       Inrad Audio mod installed
> 
> 4.       A DSP Bypass Mod (custom designed PCB) for full fidelity ssb rx
> audio has been installed (see http://omni6.wikidot.com/rxaudio) but is
> easily reversed/removed if desired.
> 
> 
> 
> Optional filters available with rig:
> 
> 1.       Inrad Roofing Filter Mod with  #765 600hz filter
> 
> 2.       Inrad #754 2800hz 9MHz IF
> 
> 3.       Inrad #753 400hz 9MHz If
> 
> 4.       Ten-Tec #221 250hz 9MHz IF (for 500hz sidetone – this filter is
> VERY rare)
> 
> 5.       Inrad #755 2800hz 6.3MHz IF
> 
> 6.       Inrad #757 2400hz 10-pole 6.3MHz IF
> 
> 7.       Inrad #758 2100hz 6.3MHz IF
> 
> 8.       Inrad #750 400hz 6.3MHz IF
> 
> 9.       Inrad #751 250hz 6.3MHz IF
> 
> A very late production, mint condition 962 power supply is also available;
> also a nice 705 microphone.  The Omni 6+ comes in an original factory
> shipping box with original manual.
> 
> Please email me directly if you are seriously interested in purchasing the
> radio and troubleshooting/repairing the rx issue.  The filters etc will not
> be sold until after the radio is sold so please don’t email me about them.
> 
> 
> 73, Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>