Re: [TenTec] Mic Wiring

[Jim Brown <k9yc@audiosystemsgroup.com>]

On 2/17/2018 7:49 AM, Greg S via TenTec wrote:
> I think the Omni C still had a high impedance mic input.... which means your 
> dynamic Midland mic probably won't have enough output to drive the mic 
> amplifier.
I used to own an Omni A that I bought new. Don't remember what mic I 
used, but I'm pretty sure it was not a Ten Tec mic. I suspect that a 
low-Z mic has a good chance of working. Wire it according to the manual 
and try it!
73, Jim K9YC

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec