The Omni C needs a Hi-Z mic. Shure 444 works great with the old Ten Tec rigs.
Winston K4CWQ
Sent from my iPhone
> On Feb 17, 2018, at 2:30 PM, Jim Brown <k9yc@audiosystemsgroup.com> wrote:
>
>> On 2/17/2018 7:49 AM, Greg S via TenTec wrote:
>> I think the Omni C still had a high impedance mic input.... which means your
>> dynamic Midland mic probably won't have enough output to drive the mic
>> amplifier.
>
> I used to own an Omni A that I bought new. Don't remember what mic I used,
> but I'm pretty sure it was not a Ten Tec mic. I suspect that a low-Z mic has
> a good chance of working. Wire it according to the manual and try it!
>
> 73, Jim K9YC
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|