Try reflowing the solder on pcb to connector pins. Maybe one of them is
cold solder joint.
On Sat, Feb 24, 2018 at 6:23 PM, Stan Gammons <email@example.com> wrote:
> Hi Everyone,
> I have an Omni VI that likes to throw fits now and then and not display
> some of the segments on the display. Seems like every time I deoxit the
> pins and or resolder connections it works for awhile then it the same ole
> same ole. Ideas on a permanent fix for this problem? I thought about
> hard wiring the driver board and display board together. That would make
> it a pain to take them out if ever needed to though.
> TenTec mailing list
TenTec mailing list