Re: [TenTec] Omni VI display

[Stan Gammons <s_gammons@charter.net>]

I've tried that and it didn't help.  The connector between the boards 
next to the S-meter seems to be the one that's causing trouble.  Guess I 
could replace the connector or hard wire the boards together.
73

Stan
KM4HQE


On 02/25/2018 12:30 PM, Ken Brown wrote:
> Try reflowing the solder on pcb to connector pins. Maybe one of them is
> cold solder joint.
>
> On Sat, Feb 24, 2018 at 6:23 PM, Stan Gammons <s_gammons@charter.net> wrote:
>
> > Hi Everyone,
> >
> > I have an Omni VI that likes to throw fits now and then and not display
> > some of the segments on the display.  Seems like every time I deoxit the
> > pins and or resolder connections it works for awhile then it the same ole
> > same ole.  Ideas on a permanent fix for this problem?   I thought about
> > hard wiring the driver board and display board together.  That would make
> > it a pain to take them out if ever needed to though.
> >
> > 73
> >
> > Stan
> > KM4HQE
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec