Speaking of which...
If anyone has an Airpax or equivalent breaker available, please drop me a note
off-list.
I will need one for the "Amp Supply" Argosy II that I picked up a short time
ago. w3wn@n3sh.org will get to me.
Thanks!
73, ron W3WN
-----Original Message-----
From: Mike Bryce <prosolar@sssnet.com>
To: kb1ckt <kb1ckt@yahoo.com>; Discussion of Ten-Tec Equipment
<tentec@contesting.com>
Sent: Thu, Mar 15, 2018 10:11 am
Subject: Re: [TenTec] Triton IV on battery
A Triton will work fine on a battery.
You should insert a magnetic circuit breaker in the power cord so the PA
transistors are protected. Airpac (?) had a 18 A breaker for that purpose and
Ten Tec sold it. That circuit breaker provided the overcorrect protection that
was inside the ten tec power supply.
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is never sure.
> On Mar 15, 2018, at 10:05 AM, Shawn Upton via TenTec <tentec@contesting.com>
> wrote:
>
> Would a Triton work ok on a 12 volt car battery? Maybe not full output, but
> no drift or click. Wondering what I could put into my car for portable ops
> (on the cheap). Not going to use this while driving, nor use with the engine
> on, nor for long periods of time.
>
> shawn kb1ckt
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|