TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI+
From: "Paul Kraemer" <elespe@lisco.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 3 Apr 2018 09:26:30 -0500
List-post: <mailto:tentec@contesting.com>
Paul
You can unplug the signal in and out of dsp on main board and touch them together
See if it is getting through the dsp
I had that problem and it was the regulator supplying voltage to dsp chip.
Paul K0UYA

-----Original Message----- From: Paul DeWitte
Sent: Tuesday, April 03, 2018 9:07 AM
To: tentec@contesting.com
Subject: [TenTec] Omni VI+

Good morning all, turned on my Omni VI+ this morning and I have no
receive audio of rf signals.
What I do have is atmospheric noise on all bands but no signals either
SSB or CW.

I have tried master reset twice. Checked for loose connections inside
with no luck.

I do have TX output.

Corsair II on same antennas work fine.

Any suggestions?

Thannks,73
Paul K9OT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>