If the AGC is working, you will not be able to easily perceive if the signals
are weaker one one versus the other.
You need to compare the level of a given signal versus the noise level adjacent
to that signal. It is best to do this with the AGC shut off.
Compare the two Omni 5’s and determine what the noise level is on both with
given pot settings and then tune to a weak signal and compare again.
Gary
> On Jun 16, 2018, at 9:16 AM, Frank Kirschner <frank.kirschner@gmail.com>
> wrote:
>
> Martin,
>
> Does it sound lower in amplitude, or is it just the meter indication? I
> bought a used Omni V that worked fine, except the S-meter had somehow
> become misadjusted. A few moments adjusting the pots and everything was in
> order.
>
> 73,
> Frank
> KF6E
>
> On Sat, Jun 16, 2018 at 7:01 AM, Martin Pelt <n4uu73@gmail.com> wrote:
>
>> I have an omni V that receive on all bands is about 4 s units lower than my
>> other omni V. Switch for antenna is in proper position. Any ideas before I
>> try to track someone down to repair.
>>
>> 73 Martin N4UU
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|