Molex probably has a similar line but after not finding a product that
exactly matched what I had in my Corsair II, I decided to take another
run at the archives with a couple of different search terms. I finally
found this posting from 2004:
Sent: Tuesday, August 24, 2004 2:41 PM
To: tentec@contesting.com
Subject: Re: [TenTec] Ten Tec "molex" connectors
Michael, Dana A wrote:
> The small white connectors used in the Ten-Tec Corsairs, Argosys,
Deltas,
> Omni-V and Omni-IV are AMP MTA .100 (AMP is now a Tyco Electronics
company)
> available from Digikey and Mouser and other suppliers.
>
> The large white 4 pin and 2 pin power connector is also AMP but from the
> Universal MATE-N-LOK series. (not Molex as some have miss stated).
I found the AMP ones at Mouser and they match exactly what I have in my
radio. Thanks Bob for the reply and all the other emails suggesting
different manufacturers. I had a couple guessing AMP but couldn't figure
out the model number. I decided to repost the message from 2004 above in
case anyone else goes looking for them in the archives.
Thanks !!!
Patrick
K4PNR
On 7/4/2018 8:30 PM, Bob McGraw K4TAX wrote:
These are typically MOLEX brand connectors of the IDC type. I suggest
you download the MOLEX catalog and you can order as you need by model
number from either Digi-Key or Mouser.  Both have a good selection in
stock at reasonable prices.
73
Bob, K4TAX
On 7/4/2018 6:05 PM, Patrick wrote:
I apologize if this has been asked before as it certainly seems like
it should have been. I've been all through the archives, the wiki, and
even Google but cannot find an answer.
Where can I get the different connectors that Ten Tec used in a lot of
their older equipment, namely the Corsair II ? These are the little
clear connectors that the factory put numbers on to be plugged into
their corresponding numbered sockets on the boards.
Thanks !!!
Patrick
K4PNR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|