TenTec
[Top] [All Lists]

Re: [TenTec] ORION 2 Model 566 Motor-Boat Pulsing Sound

To: tentec@contesting.com
Subject: Re: [TenTec] ORION 2 Model 566 Motor-Boat Pulsing Sound
From: Bob McGraw K4TAX <rmcgraw@blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 30 Oct 2018 21:50:45 -0500
List-post: <mailto:tentec@contesting.com>
The capacitors on the A9 board will deteriorate with age and heat to lesser effective values of MFD or capacitance.   This causes the various regulators associated with the A9 power distribution board not to stabilize correctly and will cause initial boot up problems.   Frequently turning the radio off and then on will allow the voltage to stabilize and the microprocessor to load the operating system.   That is until next time when one finds that cycling the radio on and off a few times to get it up and running.

Also, radios of this age may have intermittent issues due to oxidation of internal connectors.   It is a good practice to thoroughly clean all connectors once ever 7 to 10 years or so. And the Molex power connector on the rear of the radio along with the mating connector on the DC cable will loosen and have poor contact.   One can use needle nose pliers to carefully tighten the pins, but they will eventually loosen again.    Look for discoloration on the white plastic/nylon housing of the connectors.  Thus replacement of both the male and female connectors is suggested.

These radios are relatively easy to repair and keep going for a long time.

73

Bob, K4TAX


On 10/30/2018 9:16 PM, MadScientist wrote:
As Ten Tec always said (when they cared) was, “Replace all of the capacitors on 
the A9 power distribution board.

That would be a good place to start.

Gary

On Oct 30, 2018, at 6:29 PM, W5SJL Amos Favorite <W5SJL@msn.com> wrote:

Hello guys this is an intermittent, if you power it down for a while it come 
back on ok.

Can’t tell if it is sourced by one of the receivers or the other since volume 
control has no effect on the sound. Transmitter power out turned all the way down.

Any Thoughts??

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Wi ndows 10

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>