in the manual,
section 2 getting started
section 2.1 describes the # operation
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
> On Nov 20, 2018, at 7:32 PM, Winston <jones_winston@bellsouth.net> wrote:
>
> I just now went back on air with the Jupiter. The # disappears when I start
> tuning, then appears about 5 seconds after tuning stops. Changing other
> settings didn’t seem to affect it, although I tried only a few.
> Again, no problems, just curious. I’ll see if I can find the manual reference.
>
> 73, Winston K4CWQ
>
> Sent from my iPhone
>
>> On Nov 20, 2018, at 7:18 PM, Mike Bryce <prosolar@sssnet.com> wrote:
>>
>> It’s in the manual, I can’t recall the actual page it’s on. but yup it means
>> the radio’s current settings have been saved.
>>
>> mike, wb8vge
>> “The trouble with quotes on the Internet is that you never know if they are
>> genuine”
>>
>> —Abraham Lincoln
>>
>>> On Nov 20, 2018, at 6:53 PM, Winston <jones_winston@bellsouth.net> wrote:
>>>
>>> It’s not a whole bunch of #s, but a single one in the right corner. It
>>> doesn’t seem to cause any problems. I’m just curious. I could find no
>>> mention of it in the manual.
>>> I suspect now, as suggested above, it means the settings have been recorded
>>> into memory.
>>>
>>> Winston K4CWQ
>>>
>>> Sent from my iPhone
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|