Aah, just noticed the bar at the bottom of the laptop "Flash Update
Utility" window, slowly creeping up, now at 9210 of 11175 lines
processed." So despite the quiet Orion it looks like progress.
On 4/4/19 7:47 PM, K3GHH wrote:
Apologies for the elementary question, but with 3.033xa running (and
even that was installed by the factory, after service) I obviously
don't do this very often. Now trying to go to xe.
I'm using an old Windows XP laptop with a cable from the O-2's serial
port to a laptop USB port through an adapter. After trial and error I
found that COM3 did not give me a "Port not found" error, so I'm using
that. The "Ten-Tec Flash32 Flash Update Utility" seems to be running,
and the laptop screen shows a "11175 total data lines in file"
message. A couple of the laptop lights are blinking; one looks like a
disk icon and another like a battery.
But there's no action showing on the Orion screen --- just "FLASH
UPDATE MODE" and "Press any key to exit." From previous work I
remember progress being shown on the O2 screen, as the manual says it
should be.
Suggestions?
-- John K3GHH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
-- John K3GHH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|