Thanks again Stuart. Have replied to all your previous but for some
obscure they haven't surfaced. Perhaps the moderators can give an
answer? 73 Malcolm F5VBU
On 4/10/2019 7:30 PM, Stuart Rohre wrote:
Some newer multi-meters have a separate switch position for diode tests.
Using that, you can identify cathode end of the diodes. and a higher
reading in the reverse direction, if the diode is not open or shorted.
Some read and display junction voltage, 0.25 Volts DC for Germanium
types and 0.5 volts for Silicon diodes.
I don't have access to an Omni VI, but the same principles apply to any
diode network in other rigs.
Hopefully, someone will have the requisite manual and drawing of the
diodes mounted on their board.
-Stuart Rohre
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|