My exact thoughts as well. Please start over and take a video or pictures, Hi
Hi.
Ken
Sent from my iPhone
> On Jul 21, 2019, at 12:40, Steven Kline via TenTec <tentec@contesting.com>
> wrote:
>
> Hi Byron,
>
> By any chance did you capture few pictures of process?
>
> Steve - W5JK
>
>> On Jul 21, 2019, at 10:50 AM, Byron Cordes via TenTec
>> <tentec@contesting.com> wrote:
>>
>>
>> Hello everyone.
>> My experience with changing Orion display . First off it works! I took me 3
>> hours . 27 minutes soldering 14 wires and the rest of time taking apart and
>> putting back together. Measuring for standoffs took the longest time but now
>> I know make them 3/32 to 1/8 inch longer than the stock. I used plastic
>> standoffs from a repeater cabinet for the insulators. I put them up against
>> the stock board post and cut the new standoffs ,worked well.
>> New display came with ribbon cable tried to cut and separate but no luck
>> there. So removed ribbon cable . Soldered 14 bread board wires about 5
>> inches long to the display. This was not easy , difficult for even a good
>> tech, just so small . I checked the connections and found pin 5 v+ wasn’t
>> soldered ! Must of flew right by it .hihi
>> Bought 90 pcb connector cut to 14 pins ,simple. Soldered 14 wires from
>> display to each pin not to bad .
>> Trimmed the 14 stud post off of cpu board so that 90 deg plug mates flat on
>> board. Need all the clearance you can get.
>> Everything else is just putting back together. You will probably have to
>> adjust contrast control (it’s on bottom of radio)
>> Happy with it ? I like the original better but this gets the radio back on
>> air. When I get some more time probably will download N4py software fore the
>> Orion.
>> Hope this helps if anyone has a bad display. 73s AC9PA Byron
>> Sent from my iPad
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|